Awesome Hooking Up A Dimmer Switch

Then tighten the screws.

Hooking up a dimmer switch. If the house wires are bent use a wire stripper to cut off the twisted ends. Here are the steps for wiring a single pole dimmer switch. As the screws tighten the switch will nudge the wires deeper into the box.

Remove the old switch from the wall. Of the insulated covering from the wires in the box and bend a loop in each with needle nose pliers. Place the loop clockwise around the screw terminals and close the loop around the screws with the needle nose pliers.

Make sure that the dimmer switch is completely flush with the outer edge of the box then attach the switch cover plate. For the dimmers with screw terminals strip 3 4 in. Screw the dimmer switch onto the electrical box by threading the mounting screws into the threaded openings on the box.

Expose at least 1 2 inches of copper wire to ensure a tight seal with the wall wires. For this you ll need one three way dimmer and one three way switch. Diycrew hrvdiy renovisionfinally a diy electrical video that shows the steps and answers questions how you can install a dimmer switch in your home visit.

Connect the ground wire from your dimmer to a green or bare copper wire in the wall box. Remove 3 4 inch of casing from the end of the house wires if needed. Other dimmers have screw terminals instead of the attached stranded wires to the new dimmer.

Open the dimmer switch and strip the rubber coating from the wires. Learn how to replace a dimmer switch.