Unique Installing Light Switch 2 Wires

However there are a lot of problems ahead which one of the key issue is about the rechargeable battery life.

Installing light switch 2 wires. To connect a wire to a terminal strip off about 1 2 inch of insulation using a wire stripper and twist the end into a clockwise loop with long nose pliers. Putting a rechargeable battery inside the switch to supply the power to the mcu or method 2. Generally used in 12vol.

Applies to spot switches non led switches basic 2 wire switches 2 prong. Like so many older houses as numerous remodels have been done over the years the light switch to one of our rooms is on the wrong side of the door. Secure the cover plate.

Turn the electricity back on and test the new switch. Ensure there is a tight connection and place the light switch back into the wall. The loop must wrap at least two thirds but no more than three quarters of the way around the terminal screw.

How to wire a toggle switch on off switch basic. You have an incoming hot wire black going to one screw it does not matter if you use the brass or silver screw on the side of the 2 way switch and a black wire from the other screw on the 2 way switch going to the load light ceiling fan etc. The white wires are wire nutted together so they can continue the circuit.

With appropriate care and use. Second twist the two white wires together and screw on a wire nut. Thinking out of the box to make mcu work with the 2 wire wiring system.

The method 1 is relatively easy. It is usually a good idea to put some black electrical tape around the nut to make sure it doesn t come off. If the light switch has a ground screw on it usually green and at the bottom of the switch connect it now.