Fabulous Two Tube Light Connection

A wide variety of tube light connector options are available to you such as 2p 4p and 3p.

Two tube light connection. I not connected to any electrical source ii one connected to live the other connected to neutral iii both connected to live or neutral scenario ii is called non shunted while scenario iii is called shunted. Lighting circuits with fluorescent tubes. Wire colors for individual and common connections on fluorescent ballasts will.

Alternatively a switch box could be added to the light table and mounted in a convenient location. Individual vs common ballast wires. Circuit of a 40w fluorescent tube with 40w ballast and starter.

Tombstones have two electrical contacts to match the two pins on a fluorescent led tube light. At the same time when the starter opened the circuit path of two. The fluorescent tube has two filaments with four terminals the starter is connected between two filaments the ballast is connected between main ac supply and one filament in tube light.

The starter is like a key of fluorescent light because it is used to light up the tube. The common wire s connect to all of the lampholders on the other side of the tubes. This describes a shunted or double ended bulb rewire.

Light source mega square 2 90 degree coupler. On this page we will refer to a fluorescent light bulb as a lamp or tube. If the light table is in a commercial style work area where there is surface conduit installed then flexible conduit should connect to a junction box where a switch could be installed.

Shunting refers to the joining of two separate circuits into one. Bond the ground wire to the fixture enclosures and use snug fitting wire connectors for your splices. When we connect the ac supply voltage to the circuit then the starter act like short circuited and current flow through those filament located at the first and second end of the tube light and the filament generate heat and it ionized the gas mercury vapor in the fluorescent tube lamp.